<<<click here for page 2
 
12.  Attach the new Autometer unit using the existing eight screws from the original bezel.  (Figure 13)
13.  Re-attach the original circuit board by engaging the board into the gauge pins and pressing on the back of the circuit board until it is fully seated to the back of the white housing.
14.  Plug the odometer cable back into the circuit board connector. (Figure 14)
Figure 13 Figure 14

15.  Remove the five white lamps on the backside of the circuit board.  Do not remove the grey light sockets.  Turn the lamps ¼ turn counter-clockwise with a pair of pliers. 16.  Plug the new lamp connector into the empty lamp socket. (Figure 15)  Note:  Lamp connector must have the red wire facing up towards the top of the cluster.
17.  Re-attach the back cover using five of the six torx screws that were removed in step 4.  The original screw from the lower centered hole will not be used. (Figure 16)
Figure 15 Figure 16
18.  Re-install new Autometer cluster into the dash by re-attaching electrical connectors, cluster, and instrument panel. See steps 1-2 in reverse order.  Here is the finished product. (Figures 17-20)
Figure 17 Figure 18
Figure 19 Figure 20